Amewi LAMA V2 SINGLE-ROTOR Bedienungsanleitung Seite 19

The helicopter vibrates very strongly
The helicopter turns left when it takes off.
The helicopter is drifting in one direction.
The helicopter drifts off strongly and cannot
be corrected by the trim.
Rotors are screwed too tightly.
Rotor shaft is bent.
The tail rotor is deformed.
The rear engine has too little power
The rear rotor is not fixed.
Rear engine is defective
The helicopter is too close to the ground.
Trim was not performed.
Servo defective
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL LAMA V2
Loosen the screws on the rotor blades
slightly.
Replace the crooked wave.
Replace the rear rotor.
Check the rear engine and rear rotor on a
fixed seat.
Replace the rear engine or the rear rotor.
Bring the helicopter to a height of one meter
Run out the trim as described in the manual.
Replace defective servos.