Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting the bell push/converter
Mount using either the double- sided
adhesive pad or the screws provided
(see Fig 3). Test your push before
fixing. Avoid fixing to metal structures.
Troubleshooting
A 'beep' sound is heard in learn mode...
¬ The push you are programming has already been learnt by the chime.
¬ If you want to change the icon associated with the push, use the un-learn procedure, then
programme the push again.
Two 'beep' sounds are heard after the normal chime sound...
¬ This indicates a low battery in the bell push that activated the chime. Fit a new battery, type CR2032.
When the bell push is operated, the amber confidence light does not turn on, or is only
on for a short time...
¬ In normal operation, the amber light will turn on for 1 second. When the battery is weak,
the light will only turn on for a short time. Fit a new battery, type CR2032.
The chime does not work...
Check that the batteries are the correct type. Only use alkaline batteries.
Check that the batteries are fitted correctly.
The chime could be out of range of the bell push. Try the chime in a different location.
The chime might not have learnt the identity of the bell push. Follow the programming procedure.
The chime does not sound...
Check that the volume control is not at the minimum setting.
Fig. 3
6
Werbung
