hkoenig MG30 Bedienungsanleitung Seite 6

The appliance will be cut off power automatically after 40 minute if it has not been
manually disconnected at the completion of brewing. For an optimum coffee taste,
serve it just after brewing.
10. Always turn the coffee maker off and disconnect the power supply when not use.
Caution: When pour coffee, the momentary inclined angle of carafe shall not be more
than 45 degree from the vertical position, you shall pour the coffee slowly until the
carafe is empty, otherwise the coffee in the carafe will rush to the bottom of carafe lid,
and the coffee will flow out from two edges of lid and hurt person!
AUTOMATIC START FUNCTION
If you do not want the coffee maker to start operation immediately, for example now it
is 5:10 pm, you hope that the coffee maker will automatically start at 8:15 in
CLOCK
1 7:1 0
the evening, first follow steps 1 to 5 of above section, then you can set the
auto m atic start function as follows:
Fig.1
1. Press PROG button one time, the word CLOCK is showed at the up-right
corner on display.
TIMER
20:1 5
2. Press the HOUR and MIN button continuously to set the present time
(real clock), that is 17:10 (See fig. 1).
Note: the time cycle is 24 hours.
Fig.2
3. Press PROG button again and the word TIMER shows on up-left corner
of display.
4. Set the delayed starting time by pressing HOUR and MIN button repetitively, that is
20:15 (see Fig. 2).
5. After setting the presetting time, press the PROG button once, the letter TIMER on
the LCD will disappear. The LCD will display the current clock. After 15s, the blue
indicator in PROG button will be extinguished.
6. Press the on/auto/off button twice, the indicator in it will illuminate blue and flash.
The LCD will display the current clock. You may see the automatic start time by pressing
PROG twice.
Note: You may cancel the automatic start function by pressing on/auto/off button once
to stop machine, if you want to brew coffee again immediately, yuo shall press
on/auto/off button once again to start brewing immediately. If you want to change the
automatic start time, only following the above 1-4 steps again.