PIR Solar Wall Light
Art.no 36-6492-1, -2 Model JY-0106A-W-PIR-W, -B
Please read the entire instruction manual before using the product
and then save it for future reference. We reserve the right for
any errors in text or images and any necessary changes made
to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
Safety
•
Handle the wall light with care, making sure not to damage
the surface of the solar cell and ensuring that it is not
covered with dust or affected by other contaminants.
•
The wall light must not be changed or modified in any way.
•
The wall light must only be repaired by qualified service
technicians using original spare parts.
•
Do not let children play with the wall light.
Product description
1
2
3
1. PIR sensor motion detector
2. Solar cell
3. Diffuser covering the LED lamp
Installation
Note:
•
The recommended installation height is 1.8–2.5 m.
•
Position the light in such a way that the solar cell can
receive as much sunlight as possible.
•
Avoid placing the light where it can be affected by other
artificial lighting such as street lights and passing cars.
GREAT BRITAIN • customer service tel: 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet: www.clasohlson.co.uk postal: 10 – 13 Market Place, Kingston Upon Thames, Surrey, KT1 1JZ
•
Ensure that the wall light is installed in the best place for
the PIR sensor to detect movement. The PIR sensor is
better at detecting movement passing across in front of it.
Movements directly towards or away from the PIR sensor
are harder to detect. The PIR sensor has a detection range
of 2–3 m in front of it within an arc of about 90°.
Use the included screws and
plugs or another appropriate
method to fasten the light to
the wall. The spacing of fixing
centres is 5 cm. Ensure that
there are no electrical wires or
water pipes in the wall where
you intend to screw/drill.
Operating instructions
1. Slide the cover on
3. Set the switch to AUTO.
the bottom of the light
forwards.
2. Remove the cover.
4. Slide the cover back and hang the light up.
5. The wall light has a built-in twilight switch which turns on
one LED lamp for decorative lighting at dusk and turns it off
at dawn. When set in the AUTO position, if the PIR sensor
detects any motion in the period from dusk to dawn, all
LEDs inside the wall light will come on.
6. If the switch is set to OFF the wall light will not come on
at all.
Note: Bear in mind that in poor light conditions it might take
several days for the battery to charge fully.
Care and maintenance
•
Clean the exterior of the lamp by wiping it with a damp cloth.
Use only mild cleaning agents, never solvents or corrosive
chemicals.
•
Always switch the light off before cleaning it.
•
Store the wall light in a dry, dust-free environment out of
children's reach whenever it is not to be used for a long time.
Troubleshooting guide
The light
•
Make sure that the switch is set to AUTO.
does not
•
The built-in battery might be flat. Make sure
come on.
that the solar cell is clean and that the light
and PIR sensor are intact.
•
Is the light placed in the best position for it to
utilise the sunlight and charge the battery?
•
Try setting the switch to OFF and letting
the light charge for 1 or 2 days of consistent
sunlight. Then set the switch to AUTO again.
Responsible disposal
This symbol indicates that this product should not
be disposed of with general household waste.
This applies throughout the entire EU. In order to
prevent any harm to the environment or health
hazards caused by incorrect waste disposal,
the product must be handed in for recycling so that
the material can be disposed of in a responsible
manner. When recycling your product, take it to your local collection
facility or contact the place of purchase. They will ensure that
the product is disposed of in an environmentally sound manner.
Specifications
Built-in battery
Rechargeable LiFePO
Charging time
Approximately 8 hours in persistent
sunlight
Approximately 8 hours (when fully charged)
Operating time
Colour temperature 2500–3000 K
IP rating
IP44
Size
14 × 9 × 6 cm
3.2 V, 500 mAh
4