Activation And Testing; Determining The Location - ELRO PRO PK4910 Anleitungshandbuch

What to do if carbon monoxide is detected?
If the carbon monoxide alarm sounds an alarm and has detected carbon monoxide, proceed as
follows:
•
Keep calm, open all doors and windows and turn off all combustion appliances.
•
If the detector continues to sound the alarm, evacuate the building. Leave all doors and
windows open and do not enter until the alarm has stopped.
•
Call the emergency number 112 and follow the instructions of the emergency responders. Seek
medical attention for anyone who may be suffering from the effects of carbon monoxide
poisoning.
•
Contact an c utility company. Do not use any combustion appliances until they have been
checked by a qualified person.

Activation and testing

Before using the carbon monoxide alarm, it is
important to activate and test it. Place the
carbon monoxide alarm on the mounting
plate (checklines in position h) and turn it
clockwise UNTIL YOU FEEL A CLICK (to
position i)! The device will now activate and
count down from 60 to 0.
After approximately 60 seconds, the carbon monoxide alarm has fully booted up. Next, check if the
device is functioning properly by pressing and holding the test/mute button for approximately 3
seconds. If the device is working properly, it will beep four times and flash red. If this is not the
case, do not use the device and contact the supplier.
NOTE:
•
The volume of the test signal is lower than the volume of the alarm signal. If you want to hear
the volume of the alarm signal, press and hold the test button for about 10 seconds. A few
seconds after the test signal, you will hear the alarm signal of > 85 dB (A).
•
During testing and activation, a battery symbol is displayed, this is NOT an indication that the
battery is low but only a display test. When the battery is reaching the end of its lifespan, the
yellow LED will light up, together with a beep, once every 40 seconds. See also the table
functionality.

Determining the location

In which room do you place a carbon monoxide detector?
•
For optimal protection, place a carbon monoxide detector in the following areas:
- In every room where a combustion appliance is present.
- In every bedroom.
- In every room where a lot of time is spent and where the alarm from other carbon monoxide
alarms may not be audible.
•
For minimal protection, place a carbon monoxide detector in the following areas:
- In every room where a combustion appliance is present.
- In the room where you spend most of your time.
-
- 4 -