V-TAC VT-5156 Installationsanweisung Seite 5

TIP: First, connect the power adapter to the camera, then the camera will sound
"Please configure camera by AP hotspot or by scanning code" then using the YCC365
Plus APP start adding the camera to the APP. If you do not hear the sound, press and
hold the "RESET" button on the device until you hear the sound "Reset Success". Please
wait until you hear the sound "Please configure camera by AP hotspot or by scanning
code"
NOTE: The camera only supports 2.4G Wi-Fi, before adding devices, make sure your
router is 2.4G Wi-Fi, and your phone is connected to 2.4G Wi-Fi.
Add Camera
•
Add camera Tap on top right corner "+" sign as shown below (figure 7)
•
Tap on "Smart Camera" as shown below(Figure 8)
•
There are three ways for adding the camera: (a) Device adding by scanning code (b)
Addition of AP hotspot (c) Addition by connecting to network cable(This feature is not
available for this camera) (Refer to Figure 9)
FIGURE 7
ADDING CAMERA DEVICE TO THE APP
FIGURE 8
ENGLISH
FIGURE 9