Safety Rules; Place Of Mounting - Elcon ELC508T Bedienungsanleitung

User manual for the following types of multiswitches:
GB
ELC508T, 512T, 516T and ELC908T, 912T, 916T
The multiswitches series ELC will be used for the distribution of 4 or 8 SAT-signals for 8 up to
16 users. All transmission levels are available for each user by programming the switching
method 14/18V, 0/22kHz and DiSEqC 2.0 (only for ELC9..T switches).
Operation only with Quattro LNB with fixed outputs Low V, Low H, High V, High H.
The terrestrial programs can be received also without connecting a SAT receiver.
The small insertion loss on the SAT-path allows the configuration of an extensive distribution
net.
High isolation of transmission levels and user connections guarantee a high signal quality
for each user.

Safety rules

! Disconnect the mains before opening the cabinet.
! Only a qualified installer is allowed to open the cabinet.
! Only the original power cable has to be used.
! In case of thunderstorm operation at the installation is not allowed.
Grounding
In conformity with EN 50083/VDE 0855 the regional safety rules should be considered at the
installation of satellite equipment.

Place of mounting

For application in dry rooms. The ambient temperature should not pass over 55° C.
The unit has to be mounted on a fireproof support.
Remarks
F-Connectors screwed only finger tight.
Cables coming from exterior have to be bent downwards and upwards again to avoid water
penetration along the cable run.
If the installation is made by using a electrical screwdriver the max. torque figures have to be
respected.
The multiswitches are made according to the following standards:
CE - EN 50083-2 - EN 60065.
8