Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING AND MAINTENANCE MANUAL
HANDLING
L Clockwise rotation (tightening): Slide "T" to
the left the rotation reverse shaft and push
"P" the trigger
(view figure Fig.4-A and
figure
Fig.4-C).
L Counter clockwise rotation (loosening):
Slide "T" to the right the rotation reverse
shaft and push "P" the trigger
Fig.4-B and figure
ACCESSORIES ASSEMBLY
When changing accessory, always disconnect
the pressure lines. Use only accessories
suitable for the job.
MAINTENANCE
At regular intervals supply it with the addition
L
of lubricant
(view figure
keep the appliance efficient and to extend its
service life.
Settimanalmente
L
della boccola del coperchio masse battenti
attraverso l'ingrassatore presente su coperchio
stesso.
Utilizzare
MOLYKOTE BR2 PLUS
Clean the supply filter and drain off the
L
condensation at regular intervals
Fig.1).
Every 6 months make the maintenaince on
L
the impact wrench with grease in the hammer
mechanism.
1. Secure the machine with a vise, with axis
the hammer cage in a vertical position
(view figure
Fig.7-A).
2. With an Allen wrench, unscrew the screws,
therefore the washers will come out. Take
out the complete cover and remove the
gaskets (if presents), the screws and the
washers
(view figure
3. Clean with a rag and lubricate with the
brush (the grease contained in service kit
included) the visible parts of the impact
mechanism
(view figure
(view figure
Fig.4-C).
Fig.1), in order to
eseguire
l'ingrassaggio
esclusivamente
grasso
(view figure
Fig.7-B).
Fig.7-C).
L Flow rate adjustment (where required): with
the help of a screwdriver for slotted screws
turn the register pin until the desired level
is selected
(view figure
levels of flow rate corresponding to 100%,
85% and 70%.
L "Square drive with hole and without retainer
ring": Insert the accessory "A" in the square
drive of the tool, use the pin "S" and the
ring "R"
(view figure
4. Put the new gasket (included in service kit).
Replace the cover, the new washers, and
screw use a dynamometric wrench the new
screws (included in service kit)
Fig.7-D).
Every three weeks run the wheel gun
L
clockwise and anticlockwise putting special
oil for Paoli air impact wrench motors (~5cc)
or very fluid oil for air tools into the air inlet.
These operations must be performed in a
suitably equipped working environment,
complete with extraction equipment for
nebulised particles. Use personal protective
equipment.Use only genuine spare parts and
authorized service organizations.
Do not carry out maintenance with improper
L
tools, make use of the attached exploded
drawing with the list of spare parts.
Indicate the parts most subject to wear, to be
L
dismantled and checked at regular intervals,
as well as a list of malfunctions, if any, and the
corrective action.
If the tool is left unused for long periods
L
we recommend putting some oil into the
air inlet and letting it run for a few seconds
before putting it away. In this way the internal
components will remain lubricated.
Fig.3). There are 3
Fig.5).
(view figure
ENGLISH
13
Werbung
