Einhell bavaria 44.191.40 Bedienungsanleitung Seite 6

Anleitung BPSG 160 AK SPK1
GB
Safety rules
The corresponding safety information can be found in
the enclosed booklet.
The Grinding and Engraving Set is designed to
perform drilling, grinding, deburring, polishing,
engraving, cutting, milling and cleaning jobs on
wood, metal and plastic in model-making,
workshop and household applications. Use the
tool and accessories only for those applications
described.
1. Items supplied (Fig. 1)
1 Drive unit
2 Aluminium case
3 Flexible shaft
4 Set of accessory parts
2. Technical data
Operating voltage of the drive unit: 230V ~ 50 Hz
Idle speed n : 10,000 - 35,000 min
0
Clamping range:
Weight of tool (without packing):
Sound pressure level: 68,3 dB(A)
Sound power level: 79,3 dB(A)
Vibration a :
w
Totally insulated
3. Layout (Fig. 2)
1 ON/OFF switch
2 Speed control buttons
3 Drill chuck nut
4 Locking knob for drill chuck
5 Display
4. Using the tool for the first time
Make sure that the drive unit is switched off.
Check that the mains voltage specified on the
rating plate of the power supply unit is the same
as your mains supply. Only then should you
insert the plug of the power supply unit into a
socket-outlet.
6
05.04.2006 11:40 Uhr
Fitting the various tools (Fig. 2)
Switch off the drive unit and disconnect it from the
power supply unit each time before you insert a tool
(and change a tool).
1. Press the button catch and turn the drill chuck
until the pin latches in place.
2. Unscrew the drill chuck nut.
3. Insert the tool of your choice in the chuck sleeve
as far as the stop and tighten the drill chuck nut.
ON/OFF switch, speed controller (Fig. 2)
Switch on the drive unit with the power switch (1).
The required speed can be set with the speed control
buttons (2).
Press the "+" button to increase the speed.
Press the "-" button to decrease the speed.
Refer to the display (5) for the set speed.
Set speed = Display x 1000
The correct speed depends on the tool used and the
type of material being processed.
Tips
-1
Exert only moderate pressure on the workpiece
3 mm
and allow it to be processed at uniform speed.
0,8 kg
You will not finish your work sooner by exerting
heavy pressure. On the contrary, heavy pressure
will cause the drive unit to slow down or stop and
< 2,5 m/s 2
will overload the motor.
II / ® For your own safety, use a vise or screw clamp to
secure small workpieces.
Directions for use
With small milling cutters / grinding pins: Use a
high speed.
With large milling cutters / grinding pins: Use a
low speed.
Precision work / engraving: Hold the drive unit
like a pen.
Rough work: Hold the drive unit like a hammer.
Using the flexible shaft (Fig. 4)
Unscrew the ring from the front of the machine
Fit the flexible shaft to the multi-tool by inserting
the internal shaft (1) into the chuck (2) and
tightening it.
Now tighten the ring (3) on the multi-tool.
Seite 6