Taurus Alpatec MG 12 LEGEND Bedienungsanleitung Seite 10

switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
PROBLEM
The compressor is opera-
ting abnormally and makes
a humming sound.
The «Tank empty» indica-
tor light lights up.
One/several indicator lights
do not light up.
Despite having observed
all indications, no cubes
are forming.
The «Tank empty» and
«Tray full» indicator lights
light up at same time.
FOR EU PRODUCT VERSIONS AND/OR IN
CASE THAT IT IS REQUESTED IN YOUR
COUNTRY:
ECOLOGY AND RECYCLABILITY OF THE
PRODUCT
- The materials of which the packaging of this
appliance consists are included in a collection,
classification and recycling system. Should you
wish to dispose of them, use the appropriate
public recycling bins for each type of material.
- The product does not contain concentrations of
substances that could be considered harmful to
the environment.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Never submerge the connector in water or any
other liquid or place it under running water.
- Then dry all parts before its assembly and
storage.
- In order to ensure optimum quality of the cubes,
it is recommended that you change the water
every 24 hours.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If any anomaly is detected, check the following
table:
POSSIBLE CAUSES
The voltage is lower than
recommended.
The water tank is empty.
There is air in the water pump.
The LEDS are blown.
Lack of coolant in the freezer or
the fan motor is damaged.
If all conditions are being
followed, the cube ejector may
be blocked.
This apliance complies with Directive 2014/35/EU
on Low Voltage, Directive 2014/30/EU on Elec-
tromagnetic Compatibility, Directive 2011/65/EU
on the restrictions of the use of certain hazardous
substances in electrical and electronic equipment
and Directive 2009/125/EC on the eco-design
requirements for energy-related products.
POSSIBLE SOLUTIONS
Do not connect the appliance to the
mains supply if the voltage indicated
on the rating plate does not corres-
pond with that of the mains voltage.
Turn off the appliance, fill the tank
and wait 3 minutes before restarting
the appliance.
Remove the silicone plug and leave
a few drops of water.
Contact your dealer or after sales
service to replace them.
Contact your dealer or after sales
service.
Turn off and disconnect the applian-
ce, in order to remove the ice cubes.
Turn the appliance back on.
This symbol means that in case you wish
to dispose of the product once its working
life has ended; take it to an authorised
waste agent for the selective collection of
Waste from Electric and Electronic
Equipment (WEEE).
This symbol means that surface could to
get hot during the use.