Cleaning; Troubleshooting; Technical Data; Notice Of Directive Conformity - Clatronic LBW 7003 Bedienungsanleitung

NOTE:
Always directly connect a USB storage medium to the
USB port to prevent any malfunctions.

Cleaning

CAUTION:
• Do not immerse the device in water.
• Do not use a wire brush or other abrasive objects.
• Do not use any caustic or abrasive cleaning agents.
• Remove the plug before cleaning.
• Clean the device with a slightly humid cloth without any
additives.

Troubleshooting

Problem Cause
The device The device is
does not work. blocked and
"hangs".
No audio Speaker is not
signal via the paired to the
Bluetooth audio source.
connection.
Volume too low.
Speaker Pairing does not
cannot be work.
connected.
Audio source is
switched off.
Bluetooth is
switched off at
the audio source.
Bluetooth version
is not supported.
LBW7003_IM
Model:....................................................................... LBW 7003
Power supply:
Power consumption: ......................................................... 75 W
Protection class: ......................................................................
Working temperature: ........................................0 °C to +45 °C
Working humidity:................................................. 20 % to 80 %
Net weight: ....................................................... approx. 3.68 kg
WLAN
Network supported: ................................................802.11 b/g/n
Frequency range: .....................................2400.0 – 2843.5 MHz
Maximum radio-frequency power transmitted: ............100 mW
WLAN Key:.....................WEP / WPA-PSK / WPA2-PSK / WAPI
Streaming: ............................................................ UPnP, DLNA
Solution
Bluetooth
Disconnect the mains
Bluetooth support: ....................................................V2.1+EDR
plug for approximately
Maximum radio-frequency power transmitted: ............. 2.5 mW
5 seconds. Then
Range: .......................................................... approx. 10 meters
switch the device back
Transmitting frequency: ...............................2.402 − 2.480 GHz
on again.
Protocols: .......................................................... A2DP / AVRCP
Check whether a
The right to make technical and design modifications in the
connection exists. If
course of continuous product development remains reserved.
necessary, pair the
speaker again to the
audio source.
Increase the volume
Hereby, CTC Clatronic International GmbH declares that
on the speaker.
the radio equipment type LBW 7003 is in compliance with
Increase the volume
Directive 2014 / 53 / EU.
on the audio source.
The full text of the EU declaration of conformity is available at
Check whether the
the following internet address: www.sli24.de
audio source supports
In the "Download" area, please enter the model name
the A2DP protocol.
LBW 7003.
Switch on the audio
Tested for operation in Great Britain.
source.
Switch on the Blue-
tooth function in the
audio source.

Meaning of the "Dustbin" Symbol

Use a different play-
back unit.
This helps avoid the potential effects of incorrect disposal on
the environment and human health.
This will contribute to the recycling and other forms of re-utili-
sation of electrical and electronic equipment.
Information concerning where the equipment can be dis-
posed of can be obtained from your local authority.

Technical Data

Input:............................................... 100 – 240 V~, 50 / 60 Hz
USB output: ................................................... DC 5 V
WEP64 / WEP128 / TKIP / AES

Notice of Directive Conformity

Disposal

Protect our environment: do not dispose of elec-
trical equipment in the domestic waste.
Please return any electrical equipment that
you will no longer use to the collection points
provided for their disposal.
1 A
21
10.07.17