TREVIDEA Girmi ST92 Bedienungsanleitung Seite 11

Keep the power cord free from knots and tangles.
Do not use the ironing system as a heating unit.
Always unplug before you fill or empty the tank.
Do not fill the tank above the maximum capacity and do
not introduce into the tank mixtures for removing stain,
vinegar, descaling agents or chemicals in general.
The iron must be used and rested on a stable surface.
When placing the iron on its iron stand, make sure that
the surface is stable. The iron should not be used if
dropped, when there are visible signs of damage, or if it
loses water during operations.
CAUTION: the iron plate gets very hot during use,
be careful not to touch it, serious risk of burns.
Do not put your face near the steam coming out the
iron plate.
1 Stainless steel plate
4 Base
7 Steam button
FILLING THE TANK
The filling operation must be performed only when the plate has been cooled down and after having
unplugged the unit from the electrical outlet. We recommend the use of demineralized water to prevent
excessive fouling (not covered by warranty).
1) Extract the water tank (3) rotating clockwise.
2) Open the silicon lid and enter the water up to the maximum level (360ml).
3) Close the lid and mount the tank to the main housing.
FUNCTION
Place the iron vertically. Plug the device to the electrical outlet.
Press the ON/OFF button (8). The function light (5) flashes to show that the iron plate is warming up. Wait
until light stops flashing to start ironing and steaming.
STEAM IRONING
Steam emission has to be activated with the button (7).
DRY IRONING
steam emission is disabled.
CLEANING
Before cleaning any part of the product, ensure that the unit is unplugged from the
electrical outlet and the ironing plate isn't hot anymore.
Any leftovers on the ironing plate can be removed with a damp cloth or with a non-abrasive detergents. Do
not scrape the ironing plate with iron sponge or metal objects. The plastic parts can be cleaned with a damp
cloth and neutral detergent, then wiped with a dry cloth. Do not immerse the unit in water.
2 Handle
5 Function light
8 ON/OFF button
Before using the steam check that the water contained in the tank is enough.
To perform dry ironing, switch on the iron, but do not press button (7). In this way the
ST92
3 Water tank
6 Housing
9 Power cord 10 Brush
10