Berner 51217 Bedienungsanleitung Seite 2

ALU-SAFETY RUNWAY
Art. 51217
VERY IMPORTANT
Read these safety instructions carefully as well as the instructions of use, operation and
maintenance. Keep this file in an accessible location to be able to find it when needed.
Any application which would not meet the condition of use of the step shall be considered
as inappropriate.
Handle the product properly and before use, check that all the parts are in good condition.
Never modify the product.
The manufacturer waives any liability in case of inappropriate use of the product.
WARNINGS
- Read, understand and apply all the instructions before using this device.
- Clear sufficient space around the step (equipment, electric wires, etc.) and if required report
its presence (particularly if the step is located near a traffic lane).
- Never exceed its rated capacity.
- If the work to be performed is located in front of a door, ensure it is locked.
- Use the step only on a flat, horizontal, sturdy, stable and clean surface
(no liquids, grease or oil).
- Never alter this product.
- Before use, inspect the product to spot any anomaly, such as cracked welds or damaged,
loose or missing parts.
- The employer shall ensure that the personal protection equipment (PPE) applicable
complies with local safety regulations enforced.
- Any product which would seem to be damaged in any way, worn or not operating properly
MUST BE REMOVED FROM SERVICE UNTIL SUCH TIME IT HAS BEEN REPAIRED OR
REPLACED.
- To prevent any tipping, always ensure the load on the step is centered.
Lack of compliance with these instructions may cause bodily injury and/or material damage.
STEP 150 kg
EN