KBS GROUP 1000 Bedienungs- Und Montageanleitung Seite 10

Recommendation of wall-fastening
Installation of the appliance
1. Use three screws to fix the retainer on the wall or ceiling.
2. Then take the buttons on both sides of the device. (Fig. on the right)
3. Last put the device into the retainer and adjust the angle of post-irradiation
and attach the button again to fix the device.
4. After installing and before using please check if the device is fastened
certainly and firmly.
Cleaning and servicing
Case
• Before cleaning, disconnect the appliance from the power supply and let it
cool down.
• After the device has cooled down, use soft cloths moisten with mild soap
for wiping and then use a dry cloth to wipe it again. Do not use detergent
or abrasives.
Cleaning of the reflector
• Take the grid off after the heater has
cooled down.
• Use soft cloths moisten with mild soap
for wiping and then use a dry cloth to
wipe it again. Do not use detergent or
abrasives.
• Do not touch the quartz rods with your fingers,
because there could be generated spots from
such a contact. Risk of burns!
• Do not use any abrasive or caustic cleaning
agents.
• Never immerse the heater in water! Danger of life!
wall
10