NEFF E1CCC0A 0 Serie Gebrauchs- Und Messanleitung Seite 44

en Installation instructions
9.3 Connecting the hob
Requirement: The cooker must be connected to the
mains, but switched off.
1. Screw the PE conductor (green/yellow) for the hob
to the cooker's earthing point ⁠ .
2.
Plug the hotplate plug into the cooker.
The colour of the cable should match the colour
shown on the label.
9.4 Installing the hob
Ensure that the cables are not trapped or pinched, and
do not route them over sharp edges.
¡ The hob can also be installed in an existing cut-out
that has a depth of 500 mm.
16
9.5 Removing the hob
1.
Disconnect the appliance from the power supply.
2. Slide the cooker out and place it in front of the unit
(and on a pedestal, if required).
3. Unplug the hotplate plug.
4. Finally, disconnect the PE conductor (green/yellow)
from the earthing screw.
5. Push out the hob from below.