Jata JEMA1502 Bedienungsanleitung Seite 8

• This appliance has been designed for domestic only. Do not use
it continuously for periods of time over 7 minutes. After this
time allow to cool for some minutes before using it again.
• Do not leave unattended while in use.
• Do not use the kneader empty.
• Don't allow children play with the appliance. Keep the
appliance out of the reach of children.
• Make sure neither the appliance nor the cable are in direct
contact with hot surfaces or objects.
• Always disconnect it from the mains when you do not use it
and before assembling / disassembling or when cleaning.
• Do not leave the blender plugged in if it is not going to be used.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel in order to avoid a danger.
Instructions of use
• Keep pressed the tilt support pusher (2) and lift up the support (3) (Fig. A).
• Place the bowl (9) into the base and turn it to the indicated direction.
• Place the rod or accessory to be used in the rod holes (5).
- MIXING ROD (6): For liquid mixes, creams, etc.
- DOUGH HOOK (7): It is designed to knead pastry and light dough.
- BEATER ACCESORY (8): To beat cream, egg whites, etc.
• Place the rods in the corresponding holes (5) pressing and turning round in order to have them correctly
fixed.
• Keep pressed the pusher (2) and move down the tilt support (3).
• Select the speed with the selector (4).
• It is advisable to begin at the lowest speed (position 1) to then increase the speed to highest speed (position
6). However, and depending on the texture of the food, you may use the highest position from the start.
• You can add more food during the functioning from the hole in the protective cap (10).
• Once you have finished, set the speed selector (4) to "0" position and unplug it from the mains.
• Keep pressed the support pusher (2) and lift it up.
• To take out the rods press upwards and turn clockwise.
• To remove the bowl (9) turn it in the indicated direction.
• To remove the protective cover (10), slide it downwards and for its subsequent installation, insert it
upwards up to the top.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning, make sure the appliance is unplugged from the mains.
• The accessories may be cleaned with soap and water. Try to do it as soon as you finish using it, because dry
texture of some foods are difficult to take out.
• Clean the body of the blender with a cloth dampened in water.
• Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the surfaces of
the appliance.
8