Manhattan Fathom 178709 Bedienungsanleitung Seite 5

•
If the headphones are in Standby mode but not connected to any A2DP devices, briefly press the
Next button (C) once to connect to the last connected A2DP device.
Near Field Communication (NFC) Operation
Make sure that your mobile phone has the NFC function and the headphones aren't low on power.
Specific NFC procedures can vary among phones: Refer to your phone manual as needed for details.
•
To automatically turn the headphones on or off, hold the phone (with the NFC function activated)
within a centimeter of the inductive area (K) of the headphones for 3 seconds.
•
To automatically enable the headphones' Bluetooth function, hold the phone (with the NFC
function activated) within a centimeter of the inductive area (K) of the headset for 5 seconds.
About the Battery
•
A new battery attains its optimal level of performance (its ability to fully power the headphones)
only after two or three complete charge and discharge cycles. The battery can be charged and
discharged hundreds of times, but it will eventually wear out.
•
When not charging the battery, disconnect the headphones from any power source. Do not leave a
fully charged battery connected to a charging circuit since overcharging may shorten battery life.
•
If a fully charged battery is left unused, it will fully discharge over a period of time. These
headphones will automatically turn off if no devices are connected during wireless operation.
• Leaving the headphones exposed to extremes in temperature for any length of time, such as in a
parked car during summer or winter, will reduce the battery life and capacity. Ideally, the battery
temperature should be maintained at 15-25˚C (59-77˚F).
• As with any batteries, do not dispose of the headphones in a fire or anywhere it could be expected
to catch fire, as the built-in battery could explode.
Operating Tips
If you're unable to connect the headphones to a device:
• Make sure that the headphones are fully charged, switched on, paired with the device and
indicating a successful connection.
• Make sure the device's Bluetooth function is activated.
• Check that the distance between the headphones and the device is no more than 10 m / 33 ft., and
that there are no obstructions such as walls or other active wireless items between two devices that
could interfere with the signal.
•
Bluetooth music devices or Bluetooth / Bluetooth stereo transmitter music devices must support
Bluetooth A2DP and Bluetooth AVRCP.
•
If the headphones are paired to more than one device at the same time, they will only connect to
the device with the strongest signal.
•
Not all phones feature the function that allows the headphones to be switched from music to
phone calls.
Operation Steps
Power on / Standby Press the Multifunction button about 3 seconds. The LED
lights red, then flashes blue.
Power off Press the Multifunction button about 3 seconds. The LED
turns red with an audio confirmation.
Pairing Press the Multifunction button about 5 seconds (until the
LED alternately flashes red and blue).
Answer/End a call Briefly press the Multifunction button.
Reject a call Press the Multifunction button for about 2 seconds (until
you hear a beep), then release.
Last number redial In Standby mode, press the Multifunction button twice.
Quick Reference Guide
Operation Steps
Play/Pause Briefly press
Increase/Decrease During a call or while listening to music, rotate the Volume
volume dial up or down to increase or decrease the volume. A
beep indicates the maximum or minimum level.
Previous Briefly press
Next Briefly press
Voice transfer During a call, press the Multifunction button for about 2
seconds (until you hear a beep). The beep indicates you've
switched between music and phone call modes.
Microphone mute Briefly press the Multifunction button twice to switch the
Mute function on or off.
II
u to play or pause music.
I
to play the previous song in a playlist.
tt
I
to play the next song in a playlist.
uu
ENGLISH
5