Baumer TA1220 Betriebsanleitung Seite 21

TA1220
Asymmetrical hysteresis
Hysteresis is configured in display units from 0 to 9999 and only
effective at limit output power off.
Limit 1
Hysteresis
Limit 2
Hysteresis
Relay 1 =
HIGH
Relay 2 =
LOW
3 Connection
This chapter is about terminal assignment and will present some
swiring examples.
3.1 Terminal assignment
Litz contact only by means of connector sleeves with insulating
enclosures for reasons of shock protection according to EN 61010.
Do not otherwise assign contacts that have been left unassigned ex
factory. We recommend to shield all sensor terminal leads and to
ground the shield on one side. Shields on both sides are recommen-
ded in case of RF interference or in case of equipotential bonding
over long distances. Sensor leads should not be in the same phase
winding as mains supply and output contact leads.
www.baumer.com 21