Jata JBCP3700 Bedienungsanleitung Seite 12

USE IN SELF MODE, WIRELESS. CHARGING THE BATTERY
• Before using for the first time, it is necessary to charge the battery.
• Connect the cable terminal in the bottom part of the appliance. and the adaptor to the mains. Connect the
USB terminal (9) to the adapter (not supplied) and the adapter to the mains.
• The charge indicator on the screen (5) will light up red while charging and the battery charge indicator will
increase progressively until it reaches 100%.
• Once charged (1,5-2 hours), the display charging indicator (5) will turn off.
• Press the switch (3) to start its operation, which has two speeds:
-1 click: Minimum speed.
-2 click: Maximum speed.
-3 click: OFF.
LUBRICATION
• For the hair clippers to work correctly it is absolutely necessary to lubricate the blades with oil before
each use.
• The display lubrication indicator (5) will light up if the device needs oil.
• Carefully pour a few drops of oil, which is provided, between the teeth of the blade, or if you have run out,
with another high quality, acid free oil.
• Turn the hair clippers on for a few seconds and clean the excess oil off with a cloth.
CUTTING GUIDE
• The shaver has 1 cutting guide (3-21 mm) which allows to have an accurately cutting.
• Insert the cutting guide (1) into the side slots and into the rear length selector (6) of the cutting head.
• To choose the cutting length measurement,
slide the selector (6) to the selected length (3-21mm).
TRIMING BEARD
• Always remember you must begin with the cutting guide set to the longest cutting position before setting it
in the lower position.
• Start by cutting from the down side of the chin and moving the clipper with soft movements upwards and
outwards.
• For the final touches and the edges always use the hair clipper without any guide.
REVIEW OF THE MOUSTACHE
• Comb the moustache downwards.
• Start with the guide in its longer position. Later you may use the shorter cutting guides.
THE FINAL TOUCHES
• Do not use the guide for the final touches.
• To get an exact and straight cut of the sideburns, neck, moustache and beard and the area around the ears,
turn the hair clippers round and place them at a straight angle with your head so the blade is in slight
contact with the skin, and shave downwards. This way you will get a perfect finishing.
MAINTENANCE AND CLEANING
• Before doing anything, make sure the hair clipper is unplugged from the mains.
• For a correct cleaning it is advisable to remove the block of the blade. To do so press on the blade with your
thumb. The block will become loose. Clean with the brush (7) the blade and the inside of the hair clippers
• To replace the block of the blade slot it in by the bottom, and press on the top until it clicks into place.
• Use a slightly damp cloth to clean the outside of the appliance.
• Do not use to clean chemical products or abrasives, metallic scourers and similar, which may deteriorate
the surfaces.
12