Witt Classic EHP30 Gebrauchsanweisung Seite 38

EN
possible fire hazard.
"If the mains cord is
damaged, should be
r e p l a c e d b y t h e
manufacturer or its after
sales service"
CAUTION: Use only
cooktop protectors
appropriately designed
b y t h e h o u s e h o l d
manufacturer or the
protectors already used
in this appliance.The
use of inappropriate
protectors could cause
accidents.
Installation
Emplacement with cutlery drawer
If you wish to mount furniture or a drawer
under the hob, a separation board must be
fitted between the two. Accidental contact
with the hot surface of the device's housing
is thus prevented.
The board must be fitted 20 mm under the
bottom cover of the hob.
Electrical connection
Before you connect the hob to the mains,
check if the voltage and frequency match
those specified on the hob label, which is
placed under the hob or on the Guarantee
card, or if applicable on the technical data
sheet, which you must keep together
with this manual throughout the product's
service life.
The electrical connection will be via an
all-pole circuit breaker or plug, whenever accessible, in
accordance with the current and with a minimum 3 mm
distance between contacts. This ensures disconnection in
emergencies and allows hob cleaning.
Only the WITT official technical service can handle or repair
the appliance, including replacement of the power cable.
Ensure that the inlet cable does not come into contact with
the hob housing or the oven housing, if it is installed in the
same unit.
Warning:
The electrical connection must be properly
grounded, following current regulations, otherwise the
hob may malfunction.
Unusual high power surges can damage the control
system (like with any electrical appliance).
Keep the Guarantee Certificate or the technical data
sheet together with the instructions manual throughout the
product's service life. These contain important technical
information.
380-415 V
1N/2L ~
fig. 1
380-415 V
2N/2L ~
380-415 V
1N/2L ~
220-240 V
1N/1L ~