Naber FEEL HE Installationshandbuch Seite 13

INSTALLATION MANUAL
AUTO ON FUNCTION
The auto-on function allows the luminaire to be switched on
automatically as soon as it receives voltage from the mains through the
converter. This function was designed to provide automatic switching on
of the luminaires in particular in show rooms with the daily activation of
electrical panels without the need to act individually on each luminaire.
AUTO OFF FUNCTION
The luminaire has a safety programme that switches FEEL off after 18
hours of continuous operation.
WARNING:
The LED module for these devices cannot be replaced and therefore in
the event of failure the entire device must be completely replaced.
- Do not use the device if the power cable and/or the connection cables
are defective. Defective cables and/or connectors must be immediately
replaced by qualified personnel authorised by DOMUS Line.
- Never run any cable through sharp corners and edges.
- Never run the cable over hot parts and always protect it against
contact with liquids.
- Never move the device holding it by the cable.
- Never disconnect the device from the power supply pulling it by the
cable.
- Never leave the device cable hanging from the mirror or in a position
where it could be dangerous for children.
- Install the device in a position that is out of the reach of children.
- If the cable needs to be secured use only insulated clips or plastic
cable ties.
- Ensure that the cable is not crushed between the wall and the mirror.
EN
- Never use extension cables that are not compatible with the original
connection system.
- Before cleaning the device ensure that you have switched it off and
wait until it has cooled.
- Never immerse the device in water.
- To clean the metallic parts of the device use a soft and dry cloth and
never, under any circumstances, use liquid detergents, abrasive
products or similar items that could irreparably scratch and damage the
surface.
- For stubborn dirt a cloth slightly dampened with water may be used.
In this case, never bring the cloth into contact with the live electrical
parts (cables, connectors, etc.) and after cleaning, dry the device very
well and ensure that no residual dampness remains.
WARRANTY:
The warranty on the device is valid only if powered by a power supply
provided by DOMUS Line. The warranty's general terms and conditions
for this device are available at www.domusline.com