Naber FEEL HE Installationshandbuch Seite 12

INSTALLATION MANUAL
(D) and seat the connectors as illustrated in figure 3. Then attach the
profile to the clips (A) that have been secured to the installation surface.
INSTALLATION OF LUMINAIRES IN A CONTINUOUS ROW
- Secure the clips (A) to the installation surface using the screws (B)
provided in the package as illustrated in figure 1.
- Using pliers, break one of the four membranes (G) on the closing head
located on the side of the intake cable (IN) to run the power supply
cable as illustrated in figure 2. Then break out the membrane (H)
located on the side of the output cable (OUT) positioned in
correspondence to the closing head membrane located on the side of
the intake cable (IN) on the second luminaire as illustrated in figure 4.
- After extracting the intake cable (IN) from the tail profile head, attach
it to the clips that are secured to the installation surface.
- Then connect the power supply cable (F) to the intake cable (IN)
connector and seat the connectors as illustrated in figure 3.
- Then connect the output cable (OUT) connector to the intake cable
(IN) connector on the second luminaire and seat the connectors as
illustrated in figure 5.
- Lastly, attach the head profile to the clips (A) that are secured to the
installation surface.
CONNECTION OF THE LUMINAIRE TO THE POWER SUPPLY
- Connect FEEL only to a safe converter with 12Vdc for the HE
configured models with 120 LED/metre or 24 Vdc for SHE configured
models with 240 LED/metre stabilised voltage (sold separately) and
with power at least 10% higher than the total load. For the total load
calculation check plate data printed on the product label.
If more than one luminaire must be connected to the converter ensure
EN
that the total sum of the power absorbed by the luminaires (check the
plate data shown on the product label) does not exceed the maximum
power permitted by the Converter.
- DOMUS Line guarantees the product only if powered with a Converter
supplied by us.
HOW FEEL TDM WORKS (with TouchDimmer switch)
FEEL HE TDM and FEEL SHE TDM refer to configurations of the
luminaires that have a built-in electronic TouchDimmer switch that
allows switching on, switching off and brightness intensity adjustment.
As indicated in the INSTALLATION section, these configurations can be
installed individually or in combination with FEEL HE or FEEL SHE
(configurations of luminaires without switch) to allow simultaneous
switching on, switching off and dimming of all the luminaires.
ON-OFF FUNCTION
Switching the luminaire on and off takes place simply with a quick touch
of the luminaire head surface, under which the switch (E) is located that
will always be at the end of the profile as illustrated in figure 1.
DIMMER FUNCTION
A long touch allows you to adjust the brightness intensity, increasing or
decreasing it. A quick flash of the luminaire indicates that maximum
brightness has been reached.
MEMORY FUNCTION
The brightness level will be memorised until the next adjustment.