swopper CLASSIC Gebrauchsanleitung Seite 6

How to mount and use the
metal and felt gliders
The swopper without rollers is usually supplied with metal
gliders. These are suitable for use on textile-covered floors (carpet,
felt etc.), but never on floors that might become wet or damp. For
smooth floor surfaces (stone, tiles, parquet, cork, PVC and the
like) please use only felt gliders. If these are not included in the
delivery package, we will be glad to send them to you free of
charge. To change the gliders, carefully turn the swopper upside
down and remove the metal gliders using a pipe wrench. Replace
the metal gliders with the felt gliders and press or tap these
firmly into place. That's it!
The latest generation of swoppers have combi-gliders mounted
on the base ring. The top side is of light-coloured plastic for use
ontextile floorings surfaces like carpets and felt. If you need to use
the combi-gliders on hard floors like stone, tiles, parquet, etc.,
then you simply take a thin flat-bladed screwdriver and press it
into the small opening on the side of the glider. Remove the
glider and remount it with the felt surface.
How to mount and use
the rollers
If you have chosen a swopper with rollers, then rollers braked
in compliance with DIN EN 12529 are included in the delivery
package. These universal rollers can be used on practically
any type of floor. Special "Speed" rollers can also be fitted to
the swopper for use on very deep pile carpets or rough floor
surfaces.
Please use the enclosed brush-like swopper grip when using
your swopper on smooth, hard floors (parquet, laminate, stone
etc.). This prevents unwanted rolling away. You can easily mount
it yourself by exchanging it for the black rubber cap on the
underside of the base ring. Carefully turn the swopper upside
down, remove the black rubber cap on the underside and insert
the swopper grip in its place. Now, when you sit on your swop-
per on smooth floor surfaces, the spring strut makes contact
with the floor for better support. To get the swopper rolling you
must slightly lighten the load on the seat.
10
combi-gliders
Grip
To use the grip, carefully turn your
swopper upside down, remove the cap
and insert the light-coloured swopper
grip in its place.
Settings
You can adjust the swopper in three different ways to
meet your individual requirements: height, spring hardness and
sideways movement.
1. Height adjustment
Using the lever under the seat you can adjust the height conti-
nuously. The open angle of your legs (thigh to lower leg) should be
just over 90°. We recommend adjusting the height of your desk
appropriately. If this is not possible, then please adjust the seat
height to achieve an optimum distance between your eyes
and the working surface.
2. Spring hardness
You can set the spring hardness according to your weight and your
personal preference (more or less movement). The optimum setting is
when you can move freely in all directions without impediment.
Set the spring hardness by turning the sleeve on the spring strut –
down for maximum movement or low weight. Turn the sleeve
up for reduced movement or greater weight.
3. Sideways movement
The sideways movement of the swopper is decisive for activating
your muscles. The softer the setting, the more you strengthen
your muscles. We recommend starting off with a setting for reduced
sideways movement and then gradually adjusting the setting to
provide as much movement as possible. For adjustment it is best to
turn the swopper upside down and turn the handwheel towards (+)
for more sideways movement and towards (-) for less
sideways movement.
4. Backrest
The backrest height is adjustable. To adjust the height, you press
on the button on the inside of the backrest rod. Move the backrest
into the position that is most comfortable for you and then let
the button click into place.
DE EN FR NL
1
2
3
4
11