Werbung
Verfügbare Sprachen
Verfügbare Sprachen
(E)
Ambient LEDs; see page 43
WARNING: the ambient LEDs can
only be set when the headphones are
carrying out the relevant action.
+
The ambient LEDs can be switched
on/off for the following actions:
incoming calls
^
Charging the headphones
^
Press for 2 seconds: switches
X
ambient LEDs on/off
Press for longer than 5 seconds
X
(when headphones are switched
off): resets the headphones to
+
factory settings
Note: the list of stored Bluetooth
devices is deleted.
Charging the headphones
Charging the headphones
! Use only the USB cable included as part
of the scope of delivery to charge the
headphones. Failure to do so may lead to
the batteries overheating and to
malfunctions.
! Make sure that the connected end device
does not change to sleep mode during
the charging process. Otherwise the
charging process may be cancelled.
Before using the headphones for the first
time charge them using the supplied USB
cable.
®
Connect the USB cable to the headphones.
X
Connect the USB cable to a current-
X
supplying end device or use a USB power
1
plug
to connect it to an electrical socket.
i
The function LED on the headphones
lights up red during the charging process.
It lights up green, when the battery is full.
When the battery is fully discharged,
charging takes approx. 2 hours.
1 You can buy a USB power plug in a specialist shop
37
M+P-03F-9744
Werbung
