Axi LUCAS DOUBLE Gebrauchsanweisung Seite 10

LUCAS DOUBLE
EN
INTRODUCTION
Congratulations on your purchase. AXI makes every e ort to design and manufacture a robust and safe product. With this
choice, you have purchased a product that you will enjoy for years to come.
Before use, make sure all accessories are connected according to the recommended instructions in this manual.
Assembly
Assemble according to the instructions supplied with the product. Always assembly your product on at, even surface and
always according to the instruction. During the assembly, loosely t the screws at rst, fastening then tight only when fully
assembled. Check furniture ttings at least once a year - the screws may require tightening.
If possible, two or more people should assemble the product. One person can position parts while the
other hands the fasteners and tools.
Pay attention to the weather:
Please make sure that the weather is dry and windless during installation. Do not attempt to assemble the product in windy
weather, as there is a risk of damaging the panels or injury to persons. Be careful if the ground is wet or muddy.
Site selection
Avoid overhanging trees as much as possible, since leaves require regular cleaning required and broken
branches are a potential hazard. Small trees, bushes, or fences nearby can be helpful and serve as windbreaks.
Site preparation
The product's mounting location must be prepared so that the surface is level all around, a check with a spirit level is requi-
red.
The foundation can be made of treated wood or concrete, which prevents moisture from getting into the product. The pro-
duct must not be built and placed directly on grass. The foundation will become muddy on rainy days.
If a concrete slab is made, it is important that it slopes to the edges to prevent water from entering.
of water. It takes some time for the concrete or cement to set and dry completely. The product may be erected there only
when the foundation is completely dry.
The frame of the product can also be mounted on bricks, blocks or on a concrete slab.
The bricks or blocks are xed on rm and level concrete foundations. The frame is drilled and screwed to the base.
Allow enough time: If you are in a hurry, mistakes will happen and the assemblies may be assembled incorrectly. If you have
never built a product like this before, it may take longer to assemble.
Use the right tools.
Ideally, have the parts ready and check to make sure they are all there before you start building
begin. Place them on cloths or plastic sheeting if there is a risk that the parts will be scratched.
Tighten all nuts carefully and don't miss any. Check that the base frame is square. Use a spirit level that the product is moun-
ted vertically.
Safety
For domestic use only. When assembling and using - always use on rm level ground. Periodic structural checks of this pro-
duct should be undertaken, do not use if you have any doubts its tness for purpose.
Do not sit or stand on the product at any place.
Maintenance
Wipe clean with a mild soapy solution. Wipe dry with a clean and dry cloth. To ensure that you receive maximum pleasure
from your new product, it is very important for you to read this instruction. Please note, that quality guarantee of AXI is only
valid when this maintenance instruction has been followed carefully.
Keep metal parts of your product well oiled. Oil them at least once a year or when necessary.
Despite careful checking of the documents, we cannot be held responsible for printing and writing errors.
10