Procusini mini Anleitung Seite 20

5.4 Printing with 3D Choco Refills resp. own chocolate
In the main display, select the function "Print",
to start a print: The Procusini mini preheats automatically.
After the preheating phase, you can select the desired object.
To do this, press the corresponding object and follow the instructions on the
screen.
IMPORTANT: Observe the following instructions for pre­dosing.
NOTE
!
Pre­dose until the choco flows continuously from the nozzle.
If the first print after inserting a new refill starts unevenly, dose again before the
next print.
The same applies to working with chocolate.
TIP: Pre­dosing is only necessary before the first print after a cartridge change.
After the first object has been printed successfully, you can proceed directly to
the next print without dosing.
+
20