Herunterladen Diese Seite drucken

Swiss Pro+ SP-BL2000.D Bedienungsanleitung Seite 5

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 11
EN
TIMER
When the system is in standby mode, use the function knob to select the "TIMER" function, then turn the
rotary knob to adjust the time. Press 000, 010, 020, 080 or 090 and cycle through the time. Then press
the "ON/OFF" button. The blender will go into timer mode. The countdown of the digital display shows
the time remaining. After the corresponding time arrives, it is completed. The buzzer beeps 3 times and
returns to standby mode. In time work mode, rotate the speed control to select the speed acceleration.
PULSE
In the standby mode, press the "Pulse" button for 2 seconds and the motor will start working
immediately. If the button is released at any time, the motor will stop working immediately. The working
time limit is 30 seconds for each long button press. After 30 seconds, the machine will stop working
automatically. The button must be pressed again to start operation again.
ROTARY KNOB
Press this button to start or cancel when selecting or working in a mode.
7.THE METHOD OF PREPARATION OF COMMON RECIPES
* MAKING JUICE
To make juice rinse the prepared fruit, peel it, pit it and cut it into small pieces. Add a little cold water to
the blender jar. Select the "JUICE" button. Then press the "ON/OFF" button to stop the function and enjoy
the juice. When drinking, add the right amount of cold water to dilute it. It will have a better taste.
* MAKING ICE CRUSH
To make juice rinse the prepared fruit, peel it, pit it and cut it into small pieces. Prepare ice cubes (less
than 25x25x25mm) and a cup of yogurt. Pour them all into the blender jar. Select the "ICE CRUSH" button
and then press the "ON/OFF" button to wait for a tasty smoothie.
* MAKING SMOOTHIES
To make juice rinse the prepared fruit, peel it, pit it and cut it into small pieces. Prepare two cups of
yogurt and a little sugar or honey. Pour them all into the blender jar. Choose the "SMOOTHIES" button and
then press the "ON/OFF" button to wait for a tasty smoothie.
*MAKING HOT SOUPS
1. Ingredients for a warm quinoa yams drink: Quinoa 20g, yams 200g, milk 800ml. Quinoa and yams
are good for your stomach. Clean the quinoa with a sieve. Peel the yams and cut into slices. Then
steam the quinoa yams in a pan for 20 minutes.
2. Pour the cooked quinoa yams into the blender and add the milk. Choose the function "SOUP" and then
press "ON/OFF" button to drink the hot quinoa yams.
*MAKING CREAM PUMPKIN GINGER SOUP:
Ingredients: Pumpkin 500g, ginger 2g, light cream 200ml with black pepper and salt to taste. Steam the
pumpkin and ginger in a pan for 20 minutes. Add light cream, water and salt to taste. Select the "SOUP"
function and press the "ON/OFF" button. From this comes creamy pumpkin ginger soup. Sprinkle with
black pepper to make it even tastier. Do not drink raw soy milk (soy milk can be toxic if not cooked).
04
8.CIRCUIT DIAGRAM
Earthing
Safety
N
Switch
220~240V
Overload
L
Protection
Display
Board
Wiring subject to change without prior notice.
9.PROBLEM SOLVING
Problem
Possible causes
1. The power cord is not plugged in.
The indicator light
2. The stirring cup and main motor are
does not light up
not properly assembled.
The indicator light
1. Long working hours. Protect it from
is on but appliance
overheating the motor.
does not work
2. The appliance itself is out of order.
Motor
Driving
Circuit
Power Supply Board
Solution
1. Check the power cord to make sure
it is plugged in.
2. Make sure the blender jar and main
body are installed correctly.
1. Please wait an hour before using again.
2. Return it to seller or manufacturer.
EN
05

Werbung

loading