Startup / Operation; Drying Advice - BOMANN WT 5019 Bedienungsanleitung

• Connect the extractor hose to the air vent provided for this
purpose (air duct or window). The distance between the
dryer and the air vent should not be too great in order to
prevent condensation from collecting in the extractor hose.
• Route the extractor hose according to method A or B, as
shown in the diagrams below.
Electrical connection
WARNING:
• The installation to the mains supply must conform to the
local standards and regulations.
• Improper connection may cause to an electric shock!
• In no event the device should be connected to an exten-
sion cord, adapter plug or the like.
• Do not modify the plug provided with the appliance. If the
plug does not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
CAUTION: DO NOT dry in the appliance!
• Fabrics which are not tumble-dryer safe. Always follow the instruc-
tions on the care labels of your fabrics.
• Washing that has not been washed and spun.
• Washing stained with cooking oil, acetone, alcohol, fuel, petrol,
kerosene, stain remover, turpentine, wax, or wax remover. This
must be washed first in the washing machine with hot water and
detergent before drying.
• Objects such as foam rubber (latex), shower caps, waterproof
fabrics, rubberised items, and items of clothing or pillows with foam
rubber flakes.
• Softeners or similar products should be used as specified in the
softener instructions.
WARNING:
• The accessibility of the power plug must always be
ensured in order to disconnect the device from the power
supply in case of an emergency.
• Ensure that your mains power corresponds with the specifi-
cations of the appliance. The specifications are printed on
the rating label.
• Connect the mains cable to a properly installed and earthed
wall outlet.
• Use the required 9 amp fuse, a time delay fuse or circuit
breaker recommended and provide a separate power
protection for this device.
Before initial use
• Ensure that the electrical connections correspond to the
installation instructions.
• Remove all accessories and other materials from the drum.
• Clean the drum. Follow the instructions which we provide in
the chapter, "Cleaning".
• First run through a drying cycle for approx. 30 minutes with
old, damp cloth (see "Starting the dryer").

Drying advice

Startup / Operation

17