Unpacking The Appliance; Appliance Overview; Installation - BOMANN WT 5019 Bedienungsanleitung

Unpacking the Appliance

1. Remove the appliance from its packaging.
2. Remove all packaging material, such as foils, filler, cable
holder and cardboard packaging.
3. To prevent hazards, check the appliance for any transport
damage.
4. In case of damage, do not put the device into operation.
Contact your distributor.
NOTE:
Production residue or dust may have collected on the appli-
ance. We recommend cleaning the appliance according to
chapter "Cleaning".

Appliance Overview

NOTE:
The original appliance may differ from the appliance pictured
here.
1 Appliance door 4 Drum
2 Control panel 5 Door lock
3 Appliance cover 6 Mains plug
Supplied parts
1 x vent hose

Installation

CAUTION:
• Pipes and electrical fittings may only be fitted by qualified
specialists.
• During installation, the appliance must not be connected
to the mains power. Otherwise danger to life, as well as
risk of electric shock exists!
NOTE:
The appliance cover cannot be removed.
Requirements for the installation location
• Good ventilation is required around the appliance. Suf-
ficient clearance must be created for this purpose:
- Gap to the side walls and the back wall is 10 cm;
16
-
• The ambient temperature should be between 5 and 35°C.
• Install the appliance in a clean location.
• Always set the appliance onto a stable and secure surface
in order to reduce vibration and noise to a minimum.
• If the appliance does not stand level, adjust the screw-in
feet accordingly (see "Adjusting the screw-in feet").
• The appliance must be set up in such a way that the mains
socket is easily accessible.
Avoid installing:
•
-
-
-
-
- Next to volatile and inflammable materials (e.g. gas,
Adjusting the screw-in feet
7 Vent hose
Make sure that the appliance stands securely and level. Adjust
for an uneven floor by turning the screw-in feet.
8 Lint filter
9 Reset switch
The feet must have secure contact with the floor. Use a spirit
level to check whether the appliance is level. If the appliance is
not balanced, the screw-in feet must be adjusted again.
CAUTION:
The feet may not be removed. Do not block the gap between
floor and appliance with carpets, wood blocks, or similar.
This may cause a build-up of heat, which in turn impairs the
operation of the appliance.
Installation of the extractor hose
WARNING:
The extracted air may not be vented into an air duct that is
used for waste gas from appliances powered by gas or other
fuels.
The dryer has an air outlet on the back of the appliance to vent
the moist air.
Clearance in front of the appliance must be created
so that the appliance door can open without being
impeded.
On surfaces which are not heat resistant.
Next to heating appliances, a cooker, direct sunlight, or
other sources of heat.
In locations of high humidity (e.g. outdoors), since the
metal parts are susceptible to rust in these cases.
In locations in which the temperature could fall below
the freezing point. Never expose the appliance to the
elements.
petrol, alcohol, paint, etc.).
• Fit the supplied extractor hose to
the air outlet of the appliance by
turning the hose clockwise.