Scooterpac Antares 3/4 Gebrauchsanweisung Seite 19

Step 6. Once assembled the plastic clamp should be pushed up the main
frame before being tightened with the 3 allen bolts (figure 3).
Ensure the frame is held tightly and securely so there is no movement.
There must also be sufficient length of the telescopic arm within the outer tube to ensure
adequate clamping with the quick release clamp.
(Figure 3)
The canopy must be level when viewed from behind (figure 4), ensure this is so before
continuing. If necessary adjust the arms by loosening the allen bolts and sliding up or down.
(Figure 4)