Oregon Scientific BAR669A Bedienungsanleitung Seite 4

BAR669A:
• WWVB-60 generated from the atomic clock in Collins,
Colorado.
The radio signal range is 3219km (2000 miles).
NOTE BAR669: Slide the EU / UK switch to the
appropriate position for your location. Repeat each time
you reset the unit.
NOTE Initial reception takes 2-10 minutes for first set
up or when RESET is pressed. Light box will toggle red
/ green during reception. Once complete, the reception
icon will stop blinking. If the signal is weak, it can take
up to 24 hours to get a valid signal.
CLOCK RECEPTION SIGNAL
STRONG WEAK
To enable clock signal reception:
Press and hold for two seconds.
To disable clock signal reception
Press and hold for two seconds.
CLOCK
To set the clock:
1. Press and hold CLOCK to enter clock setting
2. Use
3. Press CLOCK to confirm and move onto the next
NOTE The time zone offset can be used to set the
clock up to + / - 23 hours from the received clock signal
time.
BAR669A: Time zone offset can be set to the US
time zone: (P) Pacific, (M) Mountain, (C) Central or
NO SIGNAL
(E) Eastern.
ALARM
To set the alarm:
1. Press
2. Press and hold
4
mode. The setting will blink.
/ to change the setting.
setting. The setting sequence is: time zone offset,
12 / 24 hour format, hour, minute, preset light time
ON, preset light time OFF.
to switch to alarm display.
when you are in the alarm display.
to enter alarm setting mode. The
setting will blink.
appears