Werbung
Verfügbare Sprachen
Verfügbare Sprachen
KHS e.K.
Gewerbeallee 4
45478 Muelheim / Ruhr
Germany
www.khs.net | info@khs.net
We would like to congratulate you on having purchased this KHS Inceptor Automatic, which
is a very high-quality watch. This KHS Inceptor Automatic watch ofers you high-calibre
precision with highest-quality materials and components as well as ruggedness against
shocks, variations in temperatures, water and dust.
The KHS Inceptor Automatic performs the following functions:
Analog Time Indication
Centre Second (red)
Calendar Indication
C1 Illumination system
To ensure that your KHS Inceptor Automatic operates with perfect precision for many years
to come, we advise you to pay very careful attention to the advice provided in this user's
manual. Please read the instructions pertaining specifcally to your KHS Inceptor Automatic
on the following pages.
Your KHS Inceptor is watertight up to 10 ATM. For that reason, your watch is suited, of
course, for swimming, bathing, car washing, hand washing or any other contact with water,
but the watch is not suited for diving.
To make sure that your KHS Inceptor remains watertight, we recommend you to take it to an
authorised KHS dealer to have them check all the seals and the crystal periodically.
We also advise you to have the battery replaced every 2 years.
Do NOT allow your KHS Inceptor to come in contact with chemicals. In order to ensure that
your watch remains fully functional.
Make sure that the crown is pushed in to the case before allowing your watch
to come in contact with water. The crown may not be actuated, when the watch is immersed
in water or still wet. After use in saltwater, you should rinse your watch thoroughly using
freshwater and then allow it to dry completely.
| Continuation
If your KHS Inceptor Automatic does not deviate from the norm too strongly,
you should not have it re-adjusted before two months after the purchase date. If you want
to have your KHS Inceptor regulated, primarily go to your KHS specialist dealer. He will be
able to give you competent advice and best attend to your concerns.
Only trust an authorised KHS specialist dealer with the maintenance and
repair of your KHS Inceptor Automatic. We do not accept any warranty claims if the service
instructions have not been properly observed. If you do not know any KHS specialist dealer,
please contact your nearest KHS Service Center.
If your KHS Inceptor Automatic runs fast by more than two minutes a week
two months after purchase, or runs more than 40 seconds behind per week, a specialist can
generally set the watch more precisely for you.
If the accuracy fall below these limits, a corrective setting might possible have a negative
impact on the precision of your KHS Inceptor Automatic.
To ensure the stated watertightness, this KHS Inceptor Automatic is designed with a easy to
use crown-seal. The crown only has to be pulled out in order to set the time or date and
then to be pushed back in.
Take the crown between one's thumb and fnger. Afterwards pull the crown carefully
up to the frst lock-in position (Setting the date in quick mode) or the second lock-in
position (Setting the Time).
Push the crown back in to the starting position.
After every time you change the time or date, make sure that the crown
is pushed back in to ensure that the watch remains watertight.
This KHS Inceptor Automatic has a self-winding clockwork whose mainspring is wound
automatically by the natural motion of the wearer's arm, making it unnecessary to manually
wind the watch. Alternatively, your KHS Inceptor Automatic can also be wound up with the
crown. According to the manufacturer, the built-in power reserve for a completely wound
clockwork is at least 40 hours, with an accuracy of -20 and +40 seconds a day.
The accuracy primarily depend on factors that one cannot infuence, such as fuctuating
temperatures, changing air pressure conditions, jarring or shaking of the watch, irregular
winding or soiling. All these factors can result in changes to the accuracy. The accuracy can
especially fuctuate during the frst two months of wear. After 50 to 60 days of regular wear,
the accuracy generally steadies so that the actual watch speed can be measured and
adjusted by a specialist. If a watch is previously adjusted, it is possible that its accuracy will
have to be corrected .
Page 1
Werbung
