Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
e Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts can
cause malfunctions.
e Be sure to install the unit in a place where the driver is
not bothered and where there is no danger of pas-
sengers being injured in case of sudden stops.
¢ Consult with your nearest dealer if installation requires
the drilling of holes or other modifications of the vehicle.
¢ Rain water easily gets on the floor near the door. Also,
don't make an installation on the driver seat base
because it may interfere with the driver.
¢ To prevent short-circuits, be sure to disconnect the
negative battery terminal before wiring the system up.
When you finish the installation, be sure to make one
more check to be sure everything is done correctly.
Reinstall all car parts that were removed. Reconnect the
negative battery lead.
tf
Zz a
C
a
=
When installing on mounting board
Drill in the
board a pilot
hole of
2mm
in diameter.
Mounting board
@—— Hex. screw
(4x 8mm)
When installing underneath dashboard
Hex. nut (5 mm) —~.8
l
-@
Drill 5.56 — 6.0 mm
diameter hole.
&
NY e
Dashboard
—
Hex. screw
be
(4x8 mm)
ES
>
\ ere
N
Hex. screw
SS
(5x 16mm)
&
see cer eo EI SE
EP PTT
EN
OREN
ET
A
HA
ESP EPI
ENE
Werbung
