Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Tool applications:
•
Laser Weld Cutter:
Cutting bit mounting dangers:
•
Correct cutting bit mounting is necessary to prevent injury from broken or loosen bits.
•
Do not use chipped or cracked bits.
•
Tighten the bit in the chuck using the enclosed hex spanner.
•
Before cutting, test the drill bit by briefly running tool at full throttle. Be sure to use a
barrier (such as under a heavy working table) to stop any possible loosen cutting bit.
•
A broken or loosen cutting bit will cause serious hurts !
•
Never use a bit marked with a speed lower than this tool !
•
Do not wear jeweled or loose clothing and avoid long hair.
•
Choking can happen if neckwear is not kept away from tool and accessories !
•
Avoid direct contact with accessories during and after use. Safety gloves will reduce the
risk of cuts or burns.
•
Use only proper accessories retainers (refer to parts list).
•
Use cutting bits with the correct shaft diameter, dimension and approvable speed
according to the technical data of this tool.
•
This unit has been developed as laser weld cutter and must only used for this function.
Any misuse could occur serious health damage.
Dangers in use:
•
Do not lay down the device before all the rotary parts stopped
•
Do not keep the air tool running while carrying it.
•
Maintain a firm grip on the power tool and position your body and arm to allow you to
resist kickback forces. Always use auxiliary handle, if provided, for maximum control
over kickback or torque reaction during start-up. The operator can control torque
reactions or kickback forces, if proper precautions are taken
•
Never place your hand near the rotating accessory. Accessory may kickback over your
hand.
•
Switch off the unit immediately in case of blocking or twist. Disconnect the air supply and
do not switch on again until the problem is solved. Understand the reason why the tool
has been blocked and make sure that this situation will not occur once more by
counteract.
To grind, cut and flatten laser welds on motor vehicles
Safety instructions for laser weld cutter
18
Werbung
