Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Only use the vacuum/blower in dry environments. Never use it outdoors when it is raining.
Do not use the vacuum/blower if any of its guards are missing or if any of its safety devices are not working
properly.
Be very careful when cleaning the tool. Clean the vacuum/blower only when it is switched off and
disconnected from the power supply to avoid injury.
Make sure that the power cable and extension cord to be used are not damaged and are properly coiled without
knots.
Unplug the power cord from the outlet :
Before leaving the vacuum cleaner/blower unattended, even for a short time.
Before unblocking it.
Before inspecting, cleaning or performing any other operation on the appliance.
If a foreign object or other debris accidentally enters the vacuum/blower, stop it immediately and do not use
it again until it has been inspected and you are sure that the entire vacuum/blower is in good working order.
If the vacuum/blower makes an unusual noise or starts to vibrate abnormally, STOP IT immediately and
unplug the vacuum/blower from the power outlet and try to identify the cause of the problem. Excessive
vibration can damage the vacuum/blower and injure the operator.
Residual risks
It is impossible to eliminate all residual risk factors, even if the instructions for using the tool are followed.
The following risks exist due to the construction and design of the tool :
1) Lung damage if no effective dust mask is worn.
2) Hearing loss if no effective hearing protection is worn.
3) Strong vibrations can be harmful to health if the tool is used for too long, or if the tool is not used and
maintained according to the instructions.
CAUTION! This machine generates an electromagnetic field during operation! Under certain circumstances,
this magnetic field can interfere with active or passive medical implants! To reduce the risk of serious injury
or death, persons with medical implants should consult their physician and implant manufacturer before using
this machine!
ASSEMBLY AND ADJUSTMENTS
Caution!
The vacuum/blower must not be used or turned on until it has been fully assembled
4. Assemble wheel and blower/suction tube (Fig.2 Fig.3 Fig.4 Fig.5)
-
Pull out two wheels and blower tube, holding blower tube and install two wheel, refer to Fig.2.
-
Pull out central tube, Slide the blower tube into the central tube. Refer to Fig.3.
-
Pull out suction tube, Place the suction tube on the central tube, the suction tube clicks into place. Refer
to Fig.4.
-
Put the whole tube into the machine body. refer to Fig. 5
Werbung
