JBM 60011 Bedienungsanleitung Seite 6

4. Securely tighten the rip guide locking screw.
OPERATION
Switching On/Off
To turn it on, press the trigger switch.
To turn it off, release the trigger switch.
For continuous operation, you can press the lock-on button on
the left side of the handle.
Parallel Cut Adjustment
1. Loosen the edge guide locking screw.
2. Slide the parallel guide through the slots in the base and
adjust to the desired width.
3. Tighten the locking bolt to secure it in position.
4. Ensure that the edge guide rests against the wood along
its entire length to give a consistent parallel cuts.
Depth adjustment
1. Loosen the depth clamp lever
on the depth guide at the back
of saw.
2. Hold the base plate against the
edge of the workpiece and lift
the body of the saw until the
blade is at the right depth, de-
termined by the depth gauge
(align the scale line).
3. Secure the base plate by tightening the lever.
NOTE! For an optimal quality cut, the saw blade should not ex-
tend more than 3 mm below the workpiece.
TECHINICAL SPECIFICATIONS
Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20V-DC
No-load speed . . . . . . . . . . . . . . . . . . . . . . . . . . 4000 RPM
Blade diameter . . . . . . . . . . . . . . . . . . . . . .115 mm (4 - 1/2")
Arbor size . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 mm (3/8")
Maximum cutting depth . . . . . . . . . . . . . 90º: 42,8mm / 45º: 28mm
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.06 kg
NUM. DESCRIPTION
1 Saw blade
2 Lower blade guard
3 Lower guard lever
4 Base plate
5 Dust Extraction Port
6 Upper Blade Guard
7 Rip Guide
8 Lock-Off Button
9 Trigger Switch
10 Battery
Angle adjustment
1. Loosen the bevel scale bracket for angle adjustment using
the angle locking lever.
2. Adjust the base plate to the desired angle between 0º and
45º.
3. Tighten the bevel scale bracket.
MAINTENANCE
• Always be sure that the tool is switched off and the battery
pack is removed from the tool before attempting to perform
inspection or maintenance.
• Regularly clean the tool's air vents with compressed dry
air. Do not attempt to clean by inserting pointed objects
through openings.
• Do not use cleaning agents to clean the plastic parts of the
tool, a mild detergent on a damp cloth is recommended
instead.
• Keep cutting tools sharp and clean. Properly maintained
tools with sharp cutting edges are less likely to bind and
are easier to control.
NUM. DESCRIPTION
11 Battery release button
12 Spindle Lock Button
13 Depth Guide Bracket
14 Bevel Scale Bracket
15 Cutting depth locking lever
16 Rip Guide Locking Screw
17 Angle locking lever
18 Allen Wrench
19 Dust Tube
20 Parallel guide
· 6 ·
REF. 60011