Jata JBCP3310 Bedienungsanleitung Seite 19

LUBRICATION
• For the hair clippers to work correctly it is absolutely
necessary to lubricate the blades with oil before
each use.
• Carefully pour a few drops of lubricating oil (8), which
is provided, between the teeth of the blade, or if you
have run out, with another high quality, acid free oil.
• Turn the hair clippers on for a few seconds and clean
the excess oil off with a cloth.
CUTTING GUIDE
• The shaver have 5 cutting guides (1-2-3-4 and 5
mm) which allow to be accurately put into different
positions.
• Place the guide in the blade and press it to leave it
correctly fixed.
TRIMING BEARD
• Always remember you must begin with the cutting
guide set to the longest cutting position before setting
it in the lower position.
• Start by cutting from the down side of the chin and
moving the clipper with soft movements upwards and
outwards.
• For the final touches and the edges always use the
hair clipper without any guide.
REVIEW OF THE MOUSTACHE
• Comb the moustache downwards.
• Start with the guide in its longer position. Later you
may use the shorter cutting guides.
THE FINAL TOUCHES
• Do not use the guide for the final touches.
• To get an exact and straight cut of the sideburns,
neck, moustache and beard and the area around the
ears, turn the hair clippers round and place them at a
straight angle with your head so the blade is in slight
contact with the skin, and shave downwards. This way
you will get a perfect finishing.
MAINTENANCE AND CLEANING
• Before doing anything, make sure the hair clipper is
unplugged from the mains or disconnected.
• For a correct cleaning it is advisable to remove the
block of the blade. To do this, remove the cutting guide
and remove the screws. The block will become loose.
Clean with the brush (7) the blade and the inside of the
hair clippers.
19
JBCP3310