Jata JBCP3310 Bedienungsanleitung Seite 18

• If the power cord is damaged,
it must be replaced by the
manufacturer or by its after-
sales service or similar qualified
personnel in order to avoid any
danger
• If there is any nylon filament
found on the blades, it's due to the
quality control made in each unit.
INSTRUCTIONS OF USE
• The appliance is for cutting and doing the beard and the
moustache and for the well-finished of the sideburns and
neck and as body trimmer.
• The hair clipper may be used while connected to the mains
with the cable or else autonomously (without connecting
to the mains).
USE IN SELF MODE, WIRELESS. CHARGING THE BATTERY
• Before using for the first time, it is necessary to charge the
battery.
• Connect the cable terminal (5) in the back side of the
appliance and the plug to the mains. The device can also be
charged via a micro USB cable (not included).
• The charging light indicator (4) will light on in red colour.
• Once charged (1 hour), the charging light indicator (4) will
change to red colour.
• In order to optimise the durability of the battery bear in mind
the following pieces of advice:
- Never exceed the indicated loading times for the battery.
- It is important to discharge the battery before it is
recharged, leave it on until it stops or the power decreases
clearly.
- The battery must be recharged every 6 months if it has not
been used for said period of time.
- Also recharge if it has not been used for more than a
month.
• The device has a locking system that prevents its operation.
To do this, press and hold the ON switch (3) for a few
seconds. To unlock the switch, repeat the operation.
18