Maxspect GLAIVE Bedienungsanleitung Seite 11

Operating Instructions
2. Adjust the color of each channel
English
The first channel A (indicator light yellow) will become adjustable. Press button 3/4 to
adjust the intensity. Button 3 will increase the intensity, button 4 will decrease the
intensity. Press button 2 again to switch to channel B (indicator light blue), and so on.
The speed at which the indicator LED light blinks indicates its intensity. If the indicator
LED light does not blink, the channel is at 100% intensity. If the indicator LED light
blinks at 1s interval, the channel is at 0% intensity (turned off).
Please refer to the table in the previous page to see the color of the indicator LED light
and its corresponding channel.
The setting will be saved after 10 seconds of idling.
Infrared Remote Control – Button 6
1.
Enter the Demonstration Mode
Press the button to enter Demonstration Mode.
The fixture will slowly turn on each channel to 100% one after the other when
Demonstration Mode has been set.
Press the button again to exit this mode.
Infrared Remote Control – Button 5, 7, 8
1. Using the Preset Intensity Profiles
Press button 5, 7, 8 to switch to the preset intensity profiles. Refer to the following
tables for the preset intensity profiles.
10