Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Manual
Note: If there's other lights on the internal light sensor, the lamp will not
be on if the switch has been turned to AUTO setting. During testing, other
object (hand or arm) should be used to cover the lamp top part, then
the lamp will be ON after motion is detected. Actual range of the motion
detection sensor < 5 meter depends on mounting height/position.
Battery Warning note
- Do not throw the device into an open fire because it may explode!
- Never leave the device to charge unattended.
- Regularly check the power cord for damage.
- Do not use the device if the power cord shows signs of damage.
- Make sure the power cord cannot be trodden on or pinched.
- Do not allow the power cord to hang over sharp edges and keep it away
from hot objects or naked flames.
- Do not use the device if it has a damaged power cord, if it has become
faulty, or if it has fallen or become damaged in any way.
- Ensure that the device and power cord do not come into contact with heat
sources, hot objects or naked flames.
- Always remove the charger cable from the device once charging has been
completed.
- Do not attempt to charge the device when the battery is damaged. the
device, never insert metal objects in any opening of the USB charging port.
- The rechargeable battery is built into the device and cannot be replaced
- Leaks from battery cells can occur under extreme conditions. If the liquid
gets on the skin, wash it immediately with soap and water. If the liquid gets
into the eyes, flush them directly with clean water for at least 15 minutes
and seek medical attention.
Note: When the product will not be used for a long time and for keeping
the function of the battery, you'd better comprehensively charge the
product once a month.
Note:
- Choose a stable, solid and supportive surface and make sure the lamp
is set correctly.
- This lamp is intended for inside use! Keep away from water and charge
only indoors at all times.
- This is not a TOY, keep away from small children below 6 years.
- Do not place or immerse the lamp under water like pools and ponds! It
is not waterproof (IP20).
- Do not open or disassemble the lamp yourself, this will void the
warranty at all times.
- Do not disassemble, repair or modify the product by yourself as this
may result into an electric shock.
- Do not stand, sit on, jump or throw with the lamp at all times.
- Do not throw this product in the air to avoid damage caused by falling.
- Only use the lamp for its intended designed use as a light.
- Never touch the plug contacts with sharp or metal objects.
- Use only the original power supply and original accessories.
- Do not charge the device outdoors.
- Do not keep the adapter in the plug after charging, rather disconnect
everything and store it away safely for later use.
- Protect the device from special liquids and vapors
Operation and switch mode use
The lamps have a 3-way switch mode, which can be selected using the ON/
OFF/AUTO switch knob:
1. Mode 1: on
Switch to ON. The lamp will turn ON automatically and stays ON till switched
OFF or till the battery is empty. The max use time is approx. 6-8 hours max.
2. Mode 2: off
No light and no function or detection.
3. Mode 3: auto (motion sensor detection)
Switch to AUTO. The lamp will turn ON automatically at night/dark room
and keeps ON working like that during motion is detected and goes OFF
after 20 seconds when the last detection is recognized. The battery use time
depends on use, location and detections and is variable. It will only work in
a dark room/location and when motions are detected.
FlinQ Indoor Motion Lights
Werbung
