Herunterladen Diese Seite drucken

Werbung

Hardware
Tools needed
Accessories
included
Accessories
not included
Santeg
UniSupport
Disclaimer
If you install the product in a way that differs from this manual, this will void all
guarantees. Before installation check that the product meets all your requirements
and is not damaged. By proceeding with installation, you accept the condition of the
product.
Disclaimer
Indien u het product plaatst op een manier die afwijkt van deze handleiding, vervalt
alle garantie. Controleer voor plaatsing of het product aan al uw eisen voldoet en niet
beschadigd is. Indien u overgaat tot plaatsing, aanvaardt u de staat waarin het product
zich bevindt.
INSTALLATION GUIDE
INSTALLATIEGIDS
GUIDE D'INSTALLATION
MONTAGEANLEITUNG
110°
155°
soft closing
Ø 8 mm
155°
wood
stone
Ø 8 mm
sc
Mitra/Idra column cabinet - lacquer
soft closing
110°
110°
high
sc
sc
Clause de non-responsabilité 
Si vous installez le produit d'une manière différente de celle présentée dans ce manuel,
toutes les garanties seront invalidées. Contrôlez avant le placement si le produit répond
à toutes vos exigences et n'est pas endommagé. En procédant au placement, vous
acceptez l'état dans lequel se trouve le produit.
Haftungsausschluss
Wenn Sie das Produkt nicht genau nach den Angaben in dieser Montageanleitung ein-
bauen, verfällt die Garantie. Überprüfen Sie vor dem Einbau des Produkts, ob sämtliche
Voraussetzungen erfüllt sind und das Produkt nicht beschädigt ist. Sobald Sie mit der
Montage beginnen, sehen Sie, in welchem Zustand sich das Produkt befindet.
110°
high
86292_INSTALL_INT_ver2022.1.2

Werbung

loading

Inhaltszusammenfassung für Balmani Mitra

  • Seite 1 INSTALLATION GUIDE INSTALLATIEGIDS GUIDE D’INSTALLATION MONTAGEANLEITUNG Mitra/Idra column cabinet - lacquer Hardware 110° 110° 155° high soft closing soft closing Tools needed Ø 8 mm 155° 110° 110° wood high stone Ø 8 mm Accessories included Accessories not included Santeg UniSupport 86292_INSTALL_INT_ver2022.1.2...
  • Seite 2 UNPACKING - UITPAKKEN - DÉBALLAGE - AUSPACKEN Protect against damage. Beschermen tegen beschadiging. Protéger contre les dommages. check ! Zum schutz vor Beschädigungen. Check for damage before starting installation. Controleer op schade vóór montage. Contrôler si le produit n’est pas endommagé avant montage. Prüfen sie das Produkt auf Beschädigungen vor der Installation.
  • Seite 3 2 CABINETS - 2 KASTEN - 2 ARMOIRES - 2 SCHRANKEN Variable height does not always give an exact parallel arrangement Variabele hoogte geeft niet steeds een exacte parallele opstelling Hauteur variable ne donne pas toujours une disposition parallèle exact Variable Höhe ergibt nicht immer eine exakte parallele Anordnung FINISH - AFWERKING - FINITION - ABSCHLUSS...
  • Seite 4 HINGES - SCHARNIEREN - CHARNIÈRES - SCHARNIERE Angle limitator (one per door - één per deur - un par porte - eine pro Tür) DO NOT REMOVE to avoid damage 155° NIET VERWIJDEREN om schade te voorkomen NE PAS RETIRER pour éviter les dommages NICHT ENTFERNEN schäden zu vermeiden Disassembly - Demonteren Démontage - Demontage...

Diese Anleitung auch für:

Idra