Front Wheel; Rear Wheel - Nils Fun Rb031 Gebrauchsanleitung

18. If damage is found, stop using the product immediately and put it out of the child's reach until the product is repaired.
19. Do not use the product in any other way than the instructions in the manual.
20. It is not acceptable to use the running bike on roads where there is traffic, or any other roads on which motor vehicles are
travelling, or any other place that poses a risk to a child's health and life.
21. Do not use the product on wet, slippery surfaces, sand, gravel, etc., which may present a danger of losing your balance.
22. Do not use the product after dark, during fog or other weather conditions that reduce visibility.
23. Before using the product make sure your child understands how to use the product correctly including: how to turn and
how to stop the running bike.
24. Do not leave the product exposed to weather conditions such as rain, snow or high temperatures.
25. The product should be wiped with a soft, damp cloth.
26. Before use, ensure that the steering wheel restraint is in the correct position
1. Basket
2. Strap
3. Strap
4. Handlebar
5. Handlebar riser screew
6. Saddle
7. Frame
8. Back wheel
9. Rear axle nut

10. Front wheel

11. Front axle nut
12. Clamp
Installation steps:
1. HANDLEBAR: Install the handlebar into the frame
front tube at least as far as the minimum insertion mark
and secure the screw tightly.
3. FRONT WHEEL: Loosen the nuts on both sides of the
front axle and lock the nuts on both sides after
assembling the wheel into the fork. You must ensure the
locking tab washer fits into the hole in the fork as this
acts as a safety secondary retention device for the
wheel. Please see illustration opposite.
4. REAR WHEEL: Loosen the nuts on both sides of the front axle and lock the nuts on both sides after assembling the wheel
into the fork. You must ensure that the locking tab washer fits into the hole in the hole in the fork as this acts as a safety
secondary retention device for the wheel.
5. Wrap the leather staps of the basket around the handlebar and fasten the buckles.
2. SADDLE: Insert the saddle tube into the frame back
tube at least as far as the minimum insertion mark.
Tighten with the clamping ring.
Strona 7 z 22