Oehlbach BTR Evolution 5.0 Betriebsanleitung Seite 20

1. Before pairing the BTR Evolution 5.0 with devices, other
Bluetooth enabled devices should be turned off. This will
ensure a problem-free pairing of devices.
2. Set the selector switch of the BTR Evolution 5.0 to "TX".
Note that the BTR Evolution 5.0 is not connected to a
power supply.
3. Now connect the BTR Evolution to a power supply and
press and hold the on/off switch of the BTR Evolution 5.0
for 3 seconds to switch it on. Then press the on/off switch
twice in quick succession to enter pairing mode. The
function light should now flash rapidly.
4. the BTR Evolution 5.0 can now be found by other Blue-
tooth enabled devices and pairing is possible
5. When pairing is complete, the LED is lit continuously and
audio signals can be transmitted.
6. to switch off the BTR Evolution 5.0, press and hold the on/
off button for 3 seconds The LED will light up red twice.
BTR Evolution 5.0 as Bluetooth receiver
In receiver mode, the BTR Evolution 5.0 can be connected
to other Bluetooth enabled devices that use a Bluetooth
transmitter to send audio signals wirelessly. Here the BTR
Evolution 5.0 acts as a Bluetooth receiver. To use the BTR
Evolution 5.0 in receiver mode, set the selector switch of the
BTR Evolution 5.0 to "RX" and follow the above instructions
from point 3 onwards.
20