Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.4.1 OPERATING AND CONTROL ELEMENTS
FHU-MODEL
1
2
3
Each function can be activated by touching the respective key.
1
Settings (Switches adjustability between temperature and humidity)
2 (3 Sek)
On/Off button (switch the unit on and off)
3
Change the colour of the interior lighting between white, blue and amber
3 (3 Sek)
Activate interior lighting permanently on or via door opening
(With the door open, press and hold for 3 seconds until the light switches off or on).
4
Temperature display actual value
5
Humidity display actual value
6+7
Temperature setting buttons
1
2
3
8
Switch temperature display between Celsius and Fahrenheit
1.4.2 GERÄT EIN- UND AUSSCHALTEN
Press and hold the
-button for about 3 seconds to switch the unit on or off.
1
When the unit is switched on, a signal sounds; when the unit is switched off, 3 seconds are counted down on the
display and then the unit is switched off.
1
1
2
2
3
1.4.3 TEMPERATUREN EINSTELLEN
To set the temperature, use the
The flashing value is the value to be set.
Then use the and keys
and
4
5
6
7
10 67
4
5
6
7
8
18 10
2
3
4
5
6
7
8
4
3
5
4
5
6
6
7
7
8
8
-button to select between temperature and humidity.
10 67
to set the desired value.
18 10
18 10
39
2.5
2.5.1 FAULT DESCRIPTION
error code
8
E1, E2, E3,
E4, E5, E6,
HH
LL
00 00
Issue description
The unit can no longer be switched on
Increased working noise
Actual temperature too high
FAULTS
Issue description
No temperature sensor detected/
connection at sensor interrupted
Actual temperature is outside the
measurable range >23°C
Actual temperature is outside the
measurable range <0°C
Door open too long or door sensor
not detected.
Solution
- Is the power connection
- Fill in support form
https://swisscave.ch/swisscave/support/techall/
When reducing the temperature, starting up after a
standstill, or opening the door for a long time, the unit
may need more power to reach the set temperature in
the interior.
Is the appliance aligned?
Are there any smooth, resonance-enhancing surfaces
under and around the unit?
If the working noise is disturbing, a conventional
sound-absorbing mat can be used as shown in the
illustration of point 2.5.3.
- Is the installation location too close to a heat source?
- Is the door tightly closed?
- Is the correct desired temperature set?
Technical Supportform
40
1
2
3
4
5
Solution
Fill out support form at: https://swisscave.
ch/swisscave/support/techall/
Confirm with the
-button and observe
18 10
whether the error recurs.
Switch off the appliance to avoid damage to
the wine. Fill out support form
Close the door or set the door sensor with
the instructions in point 2.5.2.
6
7
Werbung
