Selco RC10 Betriebsanweisung Seite 19

This manual is an integral part of the unit or machine and must accompany it when it changes location or is resold.
The user must assume responsibility for maintaining this manual intact and legible at all times.
SELCO s.r.l. reserves the right to modify this manual at any time without notice.
All rights of translation and total or partial reproduction by any means whatsoever (including photocopy, film, and microfilm) are reser-
ved and reproduction is prohibited without the express written consent of SELCO s.r.l.
Edition '02
CONTENTS
1.0 INTRODUCTION . . . . . . . . . . . . . . . . . . . . .20
2.0 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . .20
3.0 DESCRIPTION OF USER INTERFACE . . . . . .20
4.0 FUNCTION KEYS . . . . . . . . . . . . . . . . . . . . .21
5.0 DESCRIPTION OF GRAPHICS SYMBOLS
FOR RC10 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22
6.0 SELECTING THE WELDING PROCESS . . . . .23
7.0 MODIFYING THE PARAMETERS . . . . . . . . . .23
8.0 DISPLAYING THE READINGS
9.0 LANGUAGE SETTING . . . . . . . . . . . . . . . . . .24
10.0 SETTING THE MMA WELDING PARAMETERS25
10.1 Setting the parameters for MMA welding
in graphics mode . . . . . . . . . . . . . . . . . . . . .25
10.2 Summary of the selections and the parameters
for MMA welding . . . . . . . . . . . . . . . . . . . . .26
11.0 DESEAMING PROCEDURE (ARC-AIR) . . . .26
11.1 Parameter selection and regolation of gouging
process (arc-air) . . . . . . . . . . . . . . . . . . . . . . .26
12.0 SETTING THE PARAMETERS FOR TIG WELDING27
12.1 Setting the parameters for TIG welding
in graphics mode . . . . . . . . . . . . . . . . . . . . .28
12.2 Summary of the selections and the parameters
for TIG welding . . . . . . . . . . . . . . . . . . . . . . .28
13.0 SETTING THE PARAMETERS FOR MIG/MAG
WELDING . . . . . . . . . . . . . . . . . . . . . . . . . . . . .30
13.1 Summary of the selections and the parameters
for MIG/MAG welding in graphics MODE . . .31
13.2 Summary of the selections and the parameters
for MIG/MAG welding . . . . . . . . . . . . . . . . .32
14.0 MEMORIZATION & MANAGEMENT OF
THE WELDING PROGRAMS . . . . . . . . . . . . . . .33
15.0 ALARM MESSAGES . . . . . . . . . . . . . . . . . .33
USE AND MAINTENANCE MANUAL
. . . . . . . . . . .23
ENGLISH
19