Adjustments Before A Ride; Saddle; Seat And Handle Bar - eBike R004 Benutzerhandbuch

Operating Instruction

Adjustments before a ride

Check the following before each ride
All screws, wheel nuts or quick release
are tight
The brakes function
The air pressure of the tyres is sufficient
The lighting system is intact
The bell is OK.

Seat and handle bar:

You bicycle is assembled by the dealer and is
in a road-worthy condition. The handle bar and
seat position is adjusted to your height. While
adjusting the seat and handle bar height, pay
attention to the minimum insertion depth marked
on the handle stem shaft and seat support.
Never pull out the handle bar or seat above
the marking! Electrical devices should not be
connected to the mains over long periods
without supervision. Hence, you should pull out
the power plug from the mains socket during
vacations or during long periods of absence.
Seat:
The seat can be adjusted in three directions:
height, inclination and distance from handle bar.
Height:
Loosen the seat clamping bolts or quick
release.
Move the seat support in or out
Tighten the clamp after making the
adjustment.
You have adjusted the seat height according to
your body size, so that, while sitting on the seat,
the tips of your toes touch the ground on both
sides.
56
Inclination of the seat and distance from
handle bar
Loosen the nut of seat piston or inner
hexagon bolt (2)
Move seat forward or backward
Incline the seat
Tighten the nut or inner hexagon bolt
Caution! The seat support must remain
clamped at least up to the mark. Otherwise
it might break, leading to a fall! Leather
seats can discolour clothes when used
initially under wet conditions. Frequent
re-adjustments of the seat can leave
permanent scratches on the surface of the
seat support due to the mechanical action.
These damages fall under normal wear
and tear, and do not constitute a case of
materials defect liability.
Handle bar and handle bar stem
The handle bar can be adjusted as follows:
Caution! After a fall on the handle bar, you
must replace the handle bar and stem.
Invisible micro cracks can lead to breakage
and therefore, pose a risk of falling!