Werbung
Verfügbare Sprachen
Verfügbare Sprachen
as explained below will result in poor performance and
seizure, voiding the manufacturer's warranty.
(For units supplied with sprocket tip guide bars only.) Lubrication
of the sprocket tip is recommended after each use of the chainsaw.
Always thoroughly clean the guide bar sprocket tip before
lubrication.
Tool for lubrication: Talon Lube Gun (disposable)
This grease gun is designed to fit the small lubrication point on the
guide bar.
The disposable lube gun is packed with grease.
TO LUBRICATE SPROCKET TIP:
WARNING:
Wear
heavy-duty
work
gloves
when
performing this application to reduce the risk of personal
injury.
Fig. 6
1. Unplug the chainsaw from the power source.
NOTE: It is not necessary to remove the saw chain to lubricate the
guide bar sprocket tip.
Lubrication can be done on the job.
2. Clean the guide bar sprocket tip.
3. Using the disposable lube gun, insert the needle nose into the
lubrication hole and inject grease until it appears at the outside
edge of the sprocket tip (Fig.6).
4. Make sure that the chain brake is deactivated. Rotate the saw
18
Werbung
