Omicron CMC 850 Schnelleinstieg Seite 4

CMC 850 Quick Start
d) Access the CMC 850's Web Interface via the function Open Web Interface.
The default Web browser starts and displays the CMC 850 start page.
2. Locate the CMC 850 in the Test Set Association and Configuration Tool
a) From the Test Universe Start Page, launch the Test Set Association and Configuration tool.
This tool associates and configures OMICRON test sets connected via Ethernet. It automatically
lists the test sets found on the network and displays their names, serial numbers, IP addresses
and whether or nor a test set is associated with any computer yet.
b) In the Test Set Association and Configuration tool, locate the CMC 850 in the device list. The
device list displays the current IP settings of the CMC 850.
c) If you need to apply new IP settings, click Set IP Configurations from the Test Sets pull-down
menu.
d) In the device list, right-click the CMC 850 entry to open a context menu.
e) Access the CMC 850's Web Interface by clicking the Open Web Interface command.
The default Web browser starts and displays the CMC 850 start page.
3. Associate the CMC 850 with your computer.
Only needed if the CMC 850 is operated by the OMICRON Test Universe.
a) Since the test set is not associated yet, the Test Set Association and Configuration tool pops up
a message asking you to press the Associate button on the back of the CMC 850.
b) Go to your test set and press the Associate button on the back once. Then confirm the mes-
sage with OK. This associates computer and test set. Test Universe modules can now work
with the test set.
4. Access the embedded functions via the Web Interface
The CMC 850's embedded functions are accessible via its Web Interface. Any common Web
browser can be used to access the CMC 850 and to make use of the embedded functions.
Alternative method to invoking the Web browser by the procedures described above:
a) Start a Web browser of your choice on your computer.
b) Enter the CMC 850's IP address (in a format like http://172.22.23.61) into the Web browser's
address bar.
c) Hit the <Return> key.
Using a CMIRIG-B interface unit
To use the OMICRON-supplied CMIRIG-B interface unit as reference for the time synchronization of
the IEC 61850 bus system, connect the CMIRIG-B's front side connector "CMC" to the CMC 850's
"external Interface" connector.
The functions provided by the CMIRIG-B are now available to the OMICRON Test Universe software.
The time-related features of the embedded functions do not interact with the CMIRIG-B.
English - 3