Aquaglide THUNDERDOME Bedienungsanleitung Seite 16

16
ASSEMBLY
1) Locate a flat, dry area with access to electrical outlet or extension cord. The best
setup position will also make launching easy, so ideally the Thunderdome tube should
be carefully carried into position at the water's edge.
NOTE: Dragging or sliding the Thunderdome over ground either before or after inflation
can cause damage. It is best to attach Aquaglide items while they are deflated. Once
fully attached with Vario-Lock cinch straps, then inflate.
2) Once in the setup/ launch position, unfold the Thunderdome completely and locate
the Main Valve. Remove the Main Valve cover and push valve plunger in. Twist the valve
stem 90 degrees to open or close the 1-Way valve feature.
3) Using a high output pump 2.5 psi (minimum), place the inflation hose with proper
adaptor into the Main Valve to inflate Thunderdome. Inflate to LOWER [1] 2.0 psi
(0,138 bar) UPPER [2] 2.5 psi (0,172 bar). Check for proper air pressure using a
manometer. After inflation, replace Main valve cover. Inflation times can vary by inflator,
but the Thunderdome should be firm and tight when completely inflated.
DO NOT OVER-FILL. Excessively high pressure can cause damage to the product
and may void the warranty. Carefully monitor air pressure in the product especially
during hot weather. Repeat this step for the secondary valve on the Thunderdome.
Inflate to LOWER [1] 2.0 psi (0,138 bar) UPPER [2] 2.5 psi (0,172 bar). Check for
proper air pressure using a manometer. After inflation replace the main valve cover.
WARNING: Do not use an air compressor to inflate tube. Air compressors are
designed for high pressure inflation and can cause tube to burst if over-inflated.
WARNING: Do not use Thunderdome without adequate air pressure - [LOWER [1]
2.0 psi (0,138 bar) UPPER [2] 2.5 psi (0,172 bar) minimum.
4) You must use an Aquaglide accessory in order to board the product. Please follow
the Vario-Lock instructions in order to properly connect Aquaglide items together.
5) To launch the product, make sure to have at least 4 people evenly spaced around
the product to help carry it. NEVER DRAG THE PRODUCT! YOU MUST LIFT AND SET
THE PRODUCT ON THE WATER TO AVOID ANY ACCIDENTAL TEARING AND/OR
ABRASION.
How to connect your Aquaglide Products using the Vario-Lock cinch strap