Inhaltsverzeichnis
Werbung
16
ASSEMBLY
1) Locate a flat, dry area with access to electrical outlet or extension cord. The best
setup position will also make launching easy, so ideally the product tube should be
carefully carried into position at the water's edge.
NOTE: Dragging or sliding the product over ground either before or after inflation can
cause damage.
2) Once in the setup/ launch position, unfold the product completely and locate the
Main Valve. Remove the Main Valve cover and push valve plunger in. Twist the valve
stem 90 degrees to open or close the 1-Way valve feature.
3) Using a high output pump, place the inflation hose with proper adaptor into the Main
Valve to inflate product. Inflate to (see inflation psi, bar requirements in Pictogram).
Check for proper air pressure using a manometer. After inflation, replace Main valve
cover. Inflation times can vary by inflator, but the product should be firm and tight when
completely inflated.
DO NOT OVERFILL. Excessively high pressure can cause damage to the product and
may void the warranty. Carefully monitor air pressure in the product especially during
hot weather. Repeat this step for the secondary valve (if applicapble) on the product.
Inflate to (see inflation psi, bar requirements in Pictogram). Check for proper air pres-
sure using a manometer. After inflation replace the main valve cover.
WARNING: Do not use an air compressor to inflate tube. Air compressors are designed
for high pressure inflation and can cause tube to burst if over-inflated.
WARNING: Do not use product without adequate air pressure - (see inflation psi, bar
requirements in Pictogram).
is the time to attach
4) If you are connecting another Aquaglide product, now
them. Please follow the Vario-Lock instructions in order to properly connect
Aquaglide items together.
NOTE: It is best to attach such items while they are deflated.
5) To launch the product, make sure to have at least 4 people evenly spaced
around the product to help carry it. NEVER DRAG THE PRODUCT! YOU
MUST LIFT AND SET THE PRODUCT ON THE WATER TO AVOID ANY ACCI-
DENTAL TEARING AND/OR ABRASION.
How to connect your Aquaglide Products using the Vario-Lock cinch strap
Werbung
Inhaltsverzeichnis
